Love this thing! It’s definitely not like cutting through butter but it is comparable to that. If you take the time to clean up your prints with this you can’t even tell that supports were used in most cases, and you won’t get any small holes left from the supports. It does have a 5 min timer to prevent overheating but I have yet to trigger it because I let go of the button while in not cutting and that seems to be better for the system I assume. Read more

No doubt you are thrown by the price, I can tell you this is worth it but .... you are still not sure. This thing cuts resin, pla, lexan, plastics, acrylics virtually all softer but rigid composites. It has changed my life and it is worth every penny. Read more

Works great as an entry-level hobbyist grade piece of equipment. Good value the money, blades are strong. Used it to open a set of headlights for a projector retrofit, it cuts smoothly and easily. Very satisfied with this product. Read more

worked great, until the 4th use, then stopped working mid cut. goes into failsafe (orange LED) immediately after pressing the "trigger" button. Initially, there was a an issue with exchanging information for warranty support, took around a week to finally get the replacement sent, but, it arrived from Taiwan in less. Item works ok, but the fact it was replaced reasonably means more and pushed me to change my review Read more

A hot knife through butter. In this case there’s no “like”. The friction heat generated when using the ultrasonic blade melts plastic. It’s great cutting thin supports with ease but beware trying to cut any thicker plastic because you’ll end up with a molten stringy mess, not a clean cut. Read more