Works great in the CR-10. But you need to update the firmware obviously. My last silent boards Mem card started not locking the card in mid print it would eject across the room. Great to have a replacement Read more

Using this motherboard to update me Ender 3 was the way to go. Incredibly silent stepper drivers. Hard to believe that it's the same printer that I'd acquired. Super easy to install as well. No issues there. Read more

فعلا لا يوجد صوت من المحركات Read more

Bought this upgrade for the base Ender 3. It had the board 4.2.2 with the noisier drivers. Removing the board was annoying. I'm not sure why there were globs of hot glue on the connectors. It's not like they could disconnect themselves, they have snap fits. I used tweezers and an angled pick to remove them. Just have to be delicate and patient while taking them off. Sometimes I would press down gently while prying off the glue. Removing the glue side ways seemed to work some times too. The cables and board are marked but taking a picture of the connections help remind you of where they should go. I found that pulling the harness inward a little bit helped get the wires closer to the connections. It was pretty straight forward once the glue was removed. You still need to flash the firmware, whatever they have on there doesn't work for the base Ender 3. Just grab the 4.2.7 firmware without accessories, download, extract, copy the bin file to an empty card and install into the printer, turn it on and wait a few seconds and done. I have to admit, it is pretty quiet. Now it's just the noisy fan which I can put up with easily. My test prints came out the same as before, pretty good. The printer was just quieter while doing it. Update: Ok, so I got a second for my second machine since the first one worked out well. It's not quite plug and play since I had to flash the firmware. And again with the hot glue but at least whoever assembled it glued it so it was easy enough to remove. I know it's the 4.2.7 board but I wished it came with the software 2.0.8.6, I really like that version that was on the 4.2.2 board. Other than those issues. The quietness (minus the fans) is really nice since I print a lot. Read more

Premium quality Read more