This case is described as being able to fit the psp 1000 series which is notoriously fidgety to transplant into a new shell. Things to note are: 1. when putting in the memory card pcb in , some mounting stubs are too high and a few mm tight for the pcb to fit. I advise heating a metal prong and gently rubbing the plastic to melt a few mm off of these plastic mounts to allow the pcb to fit and line up with the memory card opening slot on the outside. The headphone jack should also be gently filed or heated and melted away for the black headphone jack component to slide in and sit flush with he exterior of the psp. 2. The memory card balancing plastic which sit overs the previous pcb will not sit on the mounting stubs as the plastic stub to the left of the D pad is too high and should be heated slightly and melted down and a small new hole drilled into the stub to act as a pilot hole for the screw. 3. The semi circle guides for the wifi card are slighty large and make it a chore to push the pcb to sit flush which will be a problem when placing the right hand buttons after. 4.the yellow plastic that acts as a lever with the back plate and the power switch on the pcb. 5.fitting the entire faceplate and backplate together needs to be done carefully and screws should be screwed in according to where it is loose and leave the snug areas screwed in not TOO tight. 6. Transferring the umd drive spring is a nightmare because of the poor arrangement of the horizontal stub on the backplate. The "open" latch also doesn't catch very well onto the umd backplate cover. Overall it is acceptable and if you are patient , it will end up looking better than many of our battle worn PSPs that are well over 15 years old. Read more

Also zu aller erst, die Verpackung kommt, so wie sie auf meinem Foto zu sehen ist. Die Knöpfe per Gummi an der weißen Pappe. Diese ist in einem einfachen Chinabeutel so wie wir alle das mittlerweile kennen sollten. Des Weiteren ist die Qualität einfach unterirdisch, die Verschlussteile passen einfach nicht richtig und es gibt immer irgendwo eine Lücke. Dann ist bei mir hinten einfach mal das Case angebrochen, auch geil. Die innere Verarbeitung lässt auch zu wünschen übrig, irgendwelche Folien, die überlappen und vom Fenster ganz zu schweigen. Kratzer und irgendwie auch alles so milchig. Aber was habe ich erwartet von einem Produkt welches ohne Versand gerade mal 19 Euro kostet? Meine Empfehlung, kauft nicht, ihr werdet enttäuscht werden. Read more

Me ha gustado que por fin tengo la psp bien , porque la carcasa de la original estaba rota. Pero no me ha gustado que me ha costado mucho poner tanto la pieza del infrarrojos como la pieza del encendido. No hay ningún tipo de instrucciones. Los botones mejor los originales, así que no he usado los que venían con lo cual hay cierto contraste de color, tampoco es que quede mal. La calidad en general no es la misma que la original, para mi gusto es peor, algunos tornillos no encajan bien en el plástico. En fin, que dependiendo del precio, puede o no que te merezca la pena. Decir que el cambio de carcasa es un engorro, pero eso no es culpa del fabricante de esta carcasa. Read more