Safety Nailer Framing Nailer The Safety Nailer Original Nailer provides stability for the fastener allowing the fastener to be installed straighter in the member and reduce the buckling tendency of the fastener as it is being installed. The Safety Nailer Original is coupled with magnetics. -The magnets allow the fasteners to not fall out of the device during open and closing of the Nailer. -When working at heights and holding up materials the fastener will not fall out of the Nailer allowing for a more efficient work operation. -In the event of working with non-magnetic fasteners the magnets on each side of the device will attract to each other preventing the non-ferrous fastener from falling out. -Straps are stretchable and one size fits all. Straps are designed to only be strapped to your index finger while you open and close device with your thumb. -Straps allow for the user to have the Nailer loaded with a fastener and rotate the Nailer on the backside of finger. This allows user to use both hands freely while Nailer is on his hand for other work. Used to install Fasteners to include Nails, Screws and Staples larger than 1.5 inches in height. The Safety Nailer Original is designed ambidextrously, allowing both left and right-handed people the same advantages. -The 180-degree hinge allows the user to fully open the device to grab a fastener out of a bag or off the ground utilizing its magnetic forces to place the Fastener in the groove. -The striking plate allows the user to protect their fingers from a bad swing of the hammer, or a drill that falls over sideways when trying to start a screw. Our Hand Nailing Products have multiple size grooves for multiple sized fasteners. Safety Nailer Original utilizes the patented technology found in the following utility patent. Safety Nailer LLC has exclusive rights to the following patent. Safety Nailer is a Registered Trademark. U.S. Pat. No. 8,806,983